Spread Knowledge

CS601 - Data Communication - Lecture Handout 23

User Rating:  / 0
PoorBest 

Related Content: CS601 - VU Lectures, Handouts, PPT Slides, Assignments, Quizzes, Papers & Books of Data Communication

Modem Standards

  • Bell modems
    • First commercial modems by Bell Telephone Co.
    • Developed in early 1970s
  • ITU-T modem standards
    • V-series: Today’s most popular modem standards
    • Bell modem compatible: V.21/22/23/26/27/29
  • Intelligent modems
    • Hayes (or Hayes-compatible) modems
    • Modem is controlled by instructions (AT commands)
    • Automatic answering, dialing, etc.

BELL Modems

BELL Modems

ITU-T Modems

ITU-T Modems

Traditional Modems

  • Traditional modems are limited to a data rate of 33.6 Kbps as determined by Shannon’s formula Data rate ∝ Signal-to-noise ratio
  • New modems with bit rated of 56 Kbps are wide spread now

Traditional Modems

  • TX of data from A to B
  • Digital data is modulated by the modem at site A
  • Analog data is sent from the modem to to the switching station at site A using the local loop
  • At the switching station, analog data is converted digital using PCM
  • Digital data travels through the digital network of telephone company and arrives at the switching station of site B
  • At the switching station , digital data is converted to analog using inverse PCM
  • Analog data is sent from switching station at site B to the modem using the local loop
  • Analog data is demodulated by modem at site B
  • The limiting factor is step 3. Here the analog signal is quantized to create digital signal. The quantization noise resulting from this process limits the data rate to 33.6 Kbps
  • The TX of data from site B to site A follows the same steps and again the limiting factor is quantization.

RESULT:

The maximum data rate in each direction is limited to 33.6 Kbps

56K Modems

  • If one side is an ISP and the signal does not have to pass through a PCM converter , quantization is eliminated in one direction and data rate can be increased to 56 Kbps

56K Modems

Uploading

  • Transmission of data from the subscriber to the ISP(UPLOADING) follows the following steps:
  • Digital data is modulated by Modem at site A
  • Analog data is sent from the modem to the switching station at site A on the local loop
  • At the switching station, data is converted to digital signal using PCM
  • Digital data travel through the digital network of the telephone network of the telephone company and is received by the ISP computer
  • The limiting factor is again step 3
  • However user does not need high data rate since in this direction only small blocks of data is sent

DOWNLOADING

  • Tx of data from ISP to the modem at site A follows these steps:
  • Digital data is sent by the computer of ISP through the digital telephone network
  • At the switching station, digital data is converted to analog using inverse PCM
  • Analog data is sent from the switching station at site A to the modem on the local loop
  • Analog data is demodulated by modem at site A
  • Note that in this direction there is no quantization of data using PCM.
  • The limitation when uploading is not an issue an here a
  • Data can be sent at 56 Kbps
  • This is what user is looking for since larger files are typically downloaded from internet

RESULT

The maximum data rate in the uploading direction is still 33.6 Kbps but the data rate in downloading direction is now 56 Kbps

  • Why 56Kbps?
    • Switching stations of the telephone company use PCM/Inverse PCM for digitizing voice
    • 8000 samples/sec * 7 bits/sample = 56 Kbps

Summary

  • MODEM Standards
    • Bell Modems
    • ITU-T Modems
  • Traditional MODEMS
  • 56k MODEMs
  • Cable Modems

Reading Sections

  • Section 6.4, 6.5, 6.6,“Data Communications and Networking” 4th Edition by Behrouz A. Forouzan